.Observe the safety instructions of the individual adhesive · set components.

911 Carrera (996) Body equipment 6 .Observe the safety instructions of the individual adhesive set components. In addition to this manual,observe the relevantjob descriptions for installingcar windows (Group 64) in the TechnicalManual! Clamp an adjustibleelectric power drill in a conventional horizontalclamp. Pre-seta speed of 900 -1,200 rpm. 1 Preparingcartridge componentA -H4- Pierce the membranein the nozzle connection of compo- nent A (aluminiumcartridge) -H4- with a screwdriver and extend the opening. Removethe flanged cover from the end of the cartridge. Screwthe short filler nozzle (blue) -H8- on to the nozzle connection of componentA. 2 Transferringcontents of componentA Unscrewthe screw cap -HIO- on the empty mixing car- tridge -H6-, insert the preparedcartridge (componentA) -H4- in to the bonding gun -B- and insert the filler nozzle -H8- as far as possible into the mixing cartridge -H6-. Press componentA fully into the mixing cartridge. After transferring the contents, pull the filler nozzle of the cartridge (componentA) -H8- out of the mixing cartridge. 3 Preparing cartridge component B -HS- Cut off the point of the nozzle connection of componentB (plastic cartridge) -H5- with a knife. Screwthe injection nozzle (yellow)-H9- on to the nozzle connection of componentB. 4 Transferringcontents of componentB Insertthe prepared cartridge (componentB) -H5- in to the bonding gun -B- and insert the injector nozzle -H9- as far as possible into the mixing cartridge -H6-. Press compo- nent B fully into the mixing cartridge. After transferring the contents, pull the injector nozzle of the cartridge (componentB) -H9- out of the mixing car- tridge. 5 Screwingmixing rod -A- into place Close the mixing cartridge -H6- with a screw cap -HIO- and screw the mixing rod -A- by hand into the mixer of the mixingcartridge. 6 Mixing componentA and componentB Clampthe mixing rod in the prepared power drill. Switch the power drill on and allow it to turn at a speed of 900 - 1,200 rpm. Duringoperation, move the mixing cartridge axiallyfrom one end stop to the other 25 times -arrows-. Note: perform the stroke movementsrapidly. The car- tridge piston is secured at the rear and can not fall out dur- ing the mixingprocedure. 6 Processing of Porsche 2-component window bonding agents 6- 7 page 3 Printedin Germany-41, 2000 c6xxxxx5