Installing sliding roof panel · Note: Install sliding roof panel in the sliding roof frame in zero position.

911 Carrera (996) Sliding roof Installing sliding roof panel Note: Install sliding roof panel in the sliding roof frame in zero position. No. Procedure Instructions 1 Insertslidingroof panel Push gate (inset)back on the left and right. Insert the sliding roof panel in the sliding roof frame and screw in fastening screws T25 M5 x 8 slightly. 2 Adjustslidingroof panel Adjust the sliding roof panel in line with the roof contour: lower at the front Dimension A, 0 to -1,0 mm, raise at the rear, Dimension B, by 0 to +1 mm. Tighten fastening screws T25 M5 x B. Tightening torque 6 Nm (4.4 ftlb.) 3 Move sliding roof Move sliding roof panel to tilting position. Carefullypull panel to tilting position, trim of the sliding/tilting roof forwards evenlyon the left check inner panels and right until it is approx. 40 mm in front of the roof edge cut-out. Check whether the left and right-handinner side panelsin Fig. C haveengaged. If inner panels are damaged or have become detached from the groove of the sliding roof frame, take off the trim of the sliding/tilting roof with the sliding roof panel removed and replace the inner panels if necessary. See: Additionalinstructions for fitting the inner panels 4 Close sliding roof panel Move the sliding roof panel to zero position (closed), 5 Engage sliding/tilting roof trim Push sliding/tilting roof trim forward as far as the roof edge cut-out. While doing so, take care not to push trim of sliding/tilting roof upwards. This could detach or damage the inner panels. 60 40 19 Removing and installing sliding roof panel 60-5 Printed in Germany -17. 1998 996601