Installing the convertible-top covering · Damage (tearing) to the zip fastener connection on the convertible-top covering!&

Installing the convertible-top covering Caution! Damage (tearing) to the zip fastener connection on the convertible-top covering!& > The adhesion (hot-meltprocess) betweenthe rear window and the convertible-topcovering must be implementedbefore the first closure or calibration of the convertibletop. I]II Information: All pins and screw joints on the convertible-topframe must be checked for tightness before the convertible-topcovering is installed. If the convertible-topcovering is very taut (with new convertible-top covering),close the convertible top and heat the convertible-topcovering evenlyusing a heating lamp. Ensure that the convertible-topcovering is not heated for longer than 1 hour. Maintaina safe distance from the heating lamp of approx. 50 cm, then leave the vehicle overnight with the convertibletop closed. No. Procedure Instructions 1 Fastening convertible-topcovering at the main bow (convertible top unlocked). Lay the convertible-topcovering on the convertible-top frame, fit the front tightening strip in the groove of the main bow and centre. 83_A_98 Fastening convertible-topcovering at the corner bow (convertible top unlocked). Press tightening strip centre (notch marking) into groove of the corner bow (centre of the corner bow is identified by a hole). The tightening strip is secured by tapping in the seal. Coat the tension hook cloth with adhesive and stick it inside around the corner bow. 61280011 61 -36 61 28 55 Replacing convertible-top covering 9966123 Printed in Germany -33, 1999