996 Carrera Group 6 Body Equipment, Exterior / PAGE 100
A.djusting. the ~ap dimensions of the rear · side section trim
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
911 Carrera (996) Convertible top, hardtop
A.djusting. the ~ap dimensions of the rear
side section trim
114_98
Adjusting gap dimensions
(Convertibletop open and set down.)Insert
a plastic spatula under the trim and press it out.
The adjustment,Figure C, is made by means
of the Torx screws in the flap.
Dimension A = 4.0 + 2.0 mm gap width
between the rear side section trim and side
section trim.
Dimension B = 3.0 + 2.0 mm gap width
between the roll-over protection system cover
and rear side section trim.
Dimension C = :f: 1 mm offset between
the roll-over protection system cover
and rear side section trim.
61 42 19 Removing and installing rear side section flap 61 -57
Printed in Germany -7, 1998 9966153
This is a source reference. Confirm exact model applicability in the original material.