Convertible top, hardtop 911 Carrera (996) · 7. Unlockingtool to unlock the old contacts in 4. The micro sw

Convertible top, hardtop 911 Carrera (996) 7. Unlockingtool to unlock the old contacts in 4. The micro switch must be seated firmly in the the plug connection (see Workshop Equipment fastening points after the material cools. Manual,No. 155). 5. Installationof the flaps is described from Page 61 -53 to Page 61 -57 in Servo No. 61 42 19. ~- 164_98 8. Unlock the old contacts of the micro-switch wires with the unlocking tool and remove. grey in pin 3 blue in pin 4 black in pin 5 Installation 1. Reinstallthe new contacts of the micro switch wires in the same position and close the secondary locking of the plug connection with a small screwdriver again. 2. Install and fasten upper micro switch with bracket. 3. Install lower micro switch and carefully heat the fastening points (plastic) with a soldering iron until the material starts to flow. 61 -118 614119 Removing and installing micro switch for rear side section flap 99661115 Printed in Germany -23, 1999