No. Procedure Instructions · 2 Cut out rear window Fit a U-typecutting knife (

911 Carrera (996) Glazing, window control No. Procedure Instructions 2 Cut out rear window Fit a U-typecutting knife (C) to the cutter (A). Set the vibration frequency controller to 5. Cut through the bond between the body and the rear window at the top, bottom and sides. Take out the rear window. Note When cutting out the rear window,take care not to damage the surroundingsection. Pull off surrounding section Carefullydetach the surroundingsection from the rear window. If the surroundingsection is removed from the rear window undamaged,it can be re-used. 3 Only if the rear window is Fit the flashing knife (E)to the cutter (A) and use it re-instaUed to remove the adhesive residuesfrom the precoated Removeadhesivefrom the bonding section of the rear window only to such rear window an extent that the bonding section of the precoating is preserved as completely as possible. 4 Removeadhesivefrom the body Removeadhesiveresidues from the body with the cutter (A) and flashing knife (E),ensuring that a residual covering of adhesiveremains. 5 Clean and prime the window Cleanthe window aperture of the body with cleaning aperture of the body solution (H 5). Use primer (H 4) to prime damage to the top coat paint in the non-visiblearea of the windowaperture. Note Allow a drying time of at least 10 minutes after cleaning! No cleaning solution residues may remain on the body. 6486 19 Removing and installing rear window 64 -19 Printed in Germany. 6, 1997 9966415