Installing flexible rear window of Cabriolet · It is not permissible to close the convertible top with a rear 'window whic

911 Carrera (996) Glazing, window control Installing flexible rear window of Cabriolet Caution! It is not permissible to close the convertible top with a rear 'window which is not glued in!& Damage (tearing) to the zip fastener connection on the con~'ertible-top covering! > The adhesion (hot-meltprocess) betweenthe rear window and the convertible-topcovering must be implementedbefore closing the convertibletop. No. Procedure Instructions 1 Inserting rear window Insert slider at the start of the rear window zip fastener. Position rear window in the convertible top covering aperture. Preciselyalign the ends of both zip fastener halves and insert the slider. Close the zip fastener up to the wire connections. If the zip fastener is offset by more than two teeth, this will produce high stress in the window radii and should be avoided. 2 Pushingwire connectionsthrough Betweenthe zip fastener and the convertible-topcovering, push the two wire strands inward through the divided chambers of the Teflon insert. Do not cross the wire connec1tions - danger of short circuit! Close the zip fastener completely and remove the slider. 3 Fitting inner plate Insert the inner plate between the headlinerand convertible-topcovering onto the tension bow; while doing so, adjust centre of the rear window. Press inner plate againstthe convertible-topcovering at top and pull forward againstthe corner bow. Push locking elementson left and right outward. 64 85 19 Removing and installing flexible rear window of Cabriolet 64-35 Printed in Germany -37, 1999 9966431