Glazing, window control 911 Carrera (996) · No. Procedure Instructions

Glazing, window control 911 Carrera (996) No. Procedure Instructions Caution! Danger of impact with the belt strap holders fitted on wheel!& > Pay attention to the two projecting belt strap holders when working on the vehicle. 4 Fitting belt strap holders on the Removetop wheel nut on the rim edge. Screw in push rod wheel and tighten at the hexagon nut with the torque wrench. Tightening torque: 130 Nm (96 ftlb.) Push support bow onto the push rod and support it on the tyre sidewall. Tighten adjusting screw of the support. 5 Putting on pressure frame on Centre the pressure frame on the outside on the the outside convertibletop behindthe rear windowaperture. 6 Fitting support Jam the support betweenthe tension bow and the convertible-toprest. Caution! Wire strand can crack and melt off and the rear window can be destroyed during heating!& > The pressure frame must be in contact on all sides. 7 Fasteningpressure frame on the Engagethe tension belt on the belt strap holder over the outside pressure frame by the wheel on the outside and tension. The pressure frame on the outside must evenly press the convertible-topcovering againstthe rear window on all sides. The contact pressure can be checked on all sides with a -0.5 mm feeler gauge. If the tension of the transverse struts (Figure A) of the pressure frame decreases, they can be re-bentin accordance with the shape. 64 -36 64 85 19 Removing and installing flexible realr window of Cabriolet 9966431 Print led in Germany -37, 1999