64 75 19 Removingand installing side window (Cabriolet) · Removing the side window

911 Carrera (996) Glazing, window control 64 75 19 Removingand installing side window (Cabriolet) Removing the side window Releasethe side window from the clampingjaws Adjusting the side ~,indow angle in of the rear power windowwith the side-panel the vehicle's longituldinal direction lining and rear side window inner seal removed and the side window extended. To do this press the micro-switch in the windscreenframe and actuate the rocker switch at the same time until the side window is completely extended. See: ServoNo. 64 71 19 Lift the side window upward out of the rear side section slot. Installing the side window in the clamping jaws Movingthe side window into the clampingjaws on the receiving rollers equalizesthe angle of the side windowto the door window. The window bottom edge must lie against the receiving rollers in the clampingjaws. Adjust the side window according to the contour of the door window and the gap E = 9 mm. Tighten the clamping jaws after completing the adjustment. 408_98 Tightening torque: 8.5::t 1.5 Nm (6.5::t 1 ftIb.)The convertible top must be open to fit the side window. The power window must be in the upper position. Insert the side window through the side section slot into the clamping jaws of the front and rear drivers. 64 75 19 Removing and installing side window (Cabriolet) 64 -47 Printed in Germany -17, 1998 9966447