Bearing extraction - optional method only! Using Faultless IMS Tool. · STEP STEP

Bearing extraction - optional method only! Using Faultless IMS Tool. STEP STEP 16.8 16.9 Begin to extract the bearing, holding the threaded Remove puller tube by unscrewing it from the plate. rod still while tightening the nut on the puller to Remove nut off threaded rod to release it along with extract the bearing. attached bearing from the puller tube. Remove tapered sleeve insert from the bearing puller tube. Once you feel the bearing start to move into the bearing puller IMPORTANT: Slightly loosen the bolts on the Faultless IMS tube, tighten the bolts that hold the mounting plate to Tool mounting plate at this point, so that it can float on the the engine. If the bearing does not want to come out, the puller block. NOTE tube and bearing are not centered up and may need to be NOTE re-centered. Once bearing is extracted, thoroughly clean the inside of the intermediate shaft using a lint-free cloth. NOTE INSTALLATIONINSTALLATIONMANUALMANUAL PAGE 14