Technical Information · 20/17 ENU 4272 4

911 (996) Technical Information 20/17 ENU 4272 4 2.1.9 Tighten new lock nut (M12 x 1.5) on the thread of the shock absorber piston rod. 1 – Torque wrench 2 – Open-ended wrench, a/f 7 3 – Shock absorber piston rod Tightening torque 58 Nm (43 ftlb.) Counter with an open-ended wrench (a/f 7) if necessary. Figure 8 3 Concluding work 3.1 Install rear spring strut (Workshop Manual '427119 Removing and installing rear spring strut') 3.2 Fit wheels on the rear axle and lower the vehicle. 3.3 Check wheel alignment values on the rear axle and make adjustments if necessary. 42 71 20 00: ONLY for Coupé: –Removing and installing rear spring strut (2 x)– Labor time: 130 TU Includes: Removing and installing wheels 42 71 20 03: ONLY for Cabriolet: –Removing and installing rear spring strut (2 x)– Labor time: 140 TU Includes: Removing and installing wheels 42 71 38 50: –Disassembling and assembling rear spring strut (2 x)– Labor time: 80 TU Includes: Removing and installing coil springs 44 90 03 00: –Performing rear suspension alignment– Labor time: 90 TU Includes: Checking height, camber, toe and steering-angle sensor actual value Without: Adjusting vehicle at rear. Separate LO No.! AfterSales JunPage7, 72019of 7