Menu item Function · ♦MOST switch If the PCM2 is operated without addition

911 Turbo (996) PCM2/CDR23 91 Menu item Function ♦MOST switch If the PCM2 is operated without additional MOST control modules, the MOST switch must be closed. The MOST switch must only remain open when MOST control modules are connected. Using this menu item, you can code the relevant vehicle version. ♦9588 Connect and start the Porsche System Tester II and switch on the ignition. ♦Select '911 Turbo (996)' in the Vehicle type menu and confirm with the >> key. ♦Select 'PCM2' in the Control modules menu and confirm with the >> key. ♦Select 'PCM2 GW' in the 911 Turbo (996) function selection menu and confirm with the >> key. ♦Select 'Coding' in the PCM2 GW function selection menu and confirm with the >> key. ♦Select "MOST switch open/closed" in the PCM2 GW coding menu and confirm with the >> key. ♦Select 'MOST switch' in the Modify PCM2 GW coding menu and confirm with the >> key. ♦Select "MOST switch open/closed" from the menu item that is displayed and code with the F8 key. The following selection is available: ♦Open ♦Closed ♦Production mode The PCM2 is set to the low-power mode in the factory and this must be switched off on putting into service. ♦9588 Connect and start the Porsche System Tester II and switch on the ignition. ♦Select '911 Turbo (996)' in the Vehicle type menu and confirm with the >> key. ♦Select 'PCM2' in the Control modules menu and confirm with the >> key. ♦Select 'PCM2 GW' in the 911 Turbo (996) PCM2 function selection menu and confirm with the >> key. ♦Select 'Coding' in the PCM2 GW function selection and confirm with the >> key. ♦Select 'Production mode' in the PCM2 GW coding menu and confirm with the >> key. ♦Select "Production mode OFF" from the menu item displayed and code it with the F8 key. The following selection is available: ♦Production mode on. ♦Production mode off. 9101 Control unit function - gateway 91-63 page 7 Printed in Germany – 43, 2003 SgfGWlwl