fullymatted.
Back to search
996 Turbo diagnostic manual — Turbo applicability only / PAGE 1055

Alarm system I 48 911 Turbo (996)96 · Work instruction Display

Add to repair workspace
Open repair workspace
Open full manual Original source
Original manual page 1055
Read extracted page text

OCR can contain errors. Check the original page image for exact wording, warnings and specifications.

Alarm system I 48 911 Turbo (996)96 Work instruction Display OK If not OK 4 Check wire from the ♦Switch off ignition < 5 Ω Repair wiring har- alarm system control ⇒ Step 4 ness ♦Measure resistance between module to the "safe" con- → End plug A on alarm system con- tact for open circuit trol module pin 28 and pin 7 on plug of door lock on pas- senger’s side 5 Check the wire from the ♦Pull plug off central locking ∞ Ω Repair wiring har- alarm system control switch ⇒Step 6 ness module to the central → End ♦Measure resistance between locking switch for short plug A on alarm system con- circuit to ground trol module pin 29 and ground 6 Check the wire from the ♦Switch on ignition 0 V Repair wiring har- alarm system control ⇒ Step 7 ness ♦Measure voltage between plug module to the central → End A on alarm system control locking switch for short module pin 29 and ground circuit to B+ 7 Check the wire from the ♦Switch off ignition < 5 Ω Repair wiring har- alarm system control ⇒ Step 8 ness ♦Measure resistance between module to the central → End plug A on control module pin locking switch for open 29 and plug on central locking circuit switch pin 1 8 Check wire from the ♦Pull plug off the passenger’s ∞ Ω Repair wiring har- alarm system control door lock ⇒ Step 9 ness module to the central → End ♦Measure resistance between locking motor for short plug B on alarm system con- circuit to ground. trol module pin 3 and ground 9 Check wire from the ♦Switch on ignition 0 V Repair wiring har- alarm system control ⇒ Step 10 ness ♦Measure voltage between plug module to the central → End B on alarm system control locking motor for short module pin 3 and ground circuit to B+ 10 Check wire from the ♦Switch off ignition < 5 Ω Repair wiring har- alarm system control ⇒ Step 11 ness ♦Measure resistance between module to the central → End plug B on alarm system con- locking motor for open trol module pin 3 and pin 1 on circuit plug of door lock on passen- ger’s side 11 ♦Replace passenger’s door lock → End 96-48 page 2 9601 Fault code 43 43xxxi48 Printed in Germany – 4, 2001

This is a source reference. Confirm exact model applicability in the original material.