996 Turbo – Remove Wing · *Patent Pending

RennKit 996 Turbo – Remove Wing *Patent Pending 1. PROTECT FINISH OF CAR Place large towels over rear valance and rear window outside and above engine lid, add blue tape to protect edge of wing and other exposed areas. (see Fig. 2a, below). Figure 2a: Protect the Paint 2. RAISE WING (method a or b below) a. With engine lid down and latched, raise spoiler wing using dash spoiler extend rocker switch – remove key. b. NOTE: If spoiler hydraulics have completely failed (wing will not go up) use the following procedure: i. Gently pull up on one side of wing near ram and insert rolled up towel to provide a gap between wing and fixed ducktail spoiler – about an inch. The hydraulic rams have strong internal springs to pull them down – it will require a good deal of force to pull up on the wing near the hydraulic ram. ii. Pull up other side of wing and insert rolled up towel – about one inch. 1