iii. Repeat – alternating sides until there is about a 2” gap between · bottom of wing and deck lid on both sides.

iii. Repeat – alternating sides until there is about a 2” gap between bottom of wing and deck lid on both sides. c. Wing should now be about 2” away from engine lid spoiler. 3. REMOVE WING a. Using pin wrench (see Fig. 2b below – available from Rennkit™), turn each wing chrome cylinder counter-clockwise looking from above the wing (picture, right, below), to line up the outer sleeve hole with the inner fitting keyhole: b. Once the hole and slot are aligned (above left side picture) turn the wrench 1/4 turn clockwise (CW) looking from above the wing. NOTE – If the wing hydraulic mechanism is not working, CHROME TUBE MAY SUDDENLY AND WITH GREAT FORCE RETRACT DOWN INTO RAM! This could damage the paint AND the wing snaps up. A RennKit © Rennkit™ LLC | All rights Reserved Page 2 Porsche 996 Turbo Wing Removal