Note 2. Next, perform the horizontal adjustmentof the · dipped beam headlights

911 Carrera (996) Maintenance Note 2. Next, perform the horizontal adjustmentof the dipped beam headlights.To do this, line upMake the adjustmentwith the regulator switch the left, horizontal part of the lighVdark limitset to O. (Headlightbeam adjustment.) (in the case of driving on the right) with the dotted horizontal line of the adjustmentunit. Withthis alignment,preference must be given to the central zone around the salient point of the light/dark limit. b, -- A -Lateral adjustment 8_1_96 B -Height and side adjustment C -Fog light adjustment Use a standard 5 mm ball-headscrewdriver to make the headlightadjustment. Onlythe lower 29o_96 screw may be turned for height adjustment;for lateral adjustmentthe upper and lower screws Note must be turned in the same direction and for the same number of rotations. The distance betweenthe headlightsand the adjustmentunit should be as small as possible. It should not exceed 30 cm, because if the Adjustment distance is greater, it is no longer possible to clearly define the formation of the lighVdark limit in the adjustmentunit.Note Secure the plugs after making the adjustment. Set the headlight adjustment unit to For Litronic headlights the ignition must be 10 cm/10 m (1%). switched off and on after adjustmentwith the lights switchedon. After this, the adjustment 1. First, make the vertical adjustment of the must be checked again. dipped beam headlights.To do this, line up the lighVdark borderline running upwards at an angle on the right hand side with the dotted 150 line of the adjustmentunit. 03 20 00 Maintenance 03-7 Printed in Germany -18, 1998 996031