Porsche DME 7.8 — OBD II Diagnosis Manual / PAGE 494
DME 7.8 DME 7.80 · Work instruction Display OK
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
DME 7.8 DME 7.80
Work instruction Display OK If not OK
4 Perform adaptation ♦Switch on the ignition → End
♦Wait one minute
♦Do not press the accelerator
♦Switch off the ignition for at
least 10 seconds
♦Read out the fault memory
5 Check CMP sensor signal ♦Connect special tool 9637 See Figure 1 Replace CMP sen-
⇒ Step 6 sor ♦Connect engine tester; use spe-
→ End cial input
♦Positive cable to Pin III/12
♦Negative cable to Pin III/17
♦Start the engine
0-55 page 2 2839 P0341
p0341 Printed in Germany, 2000
This is a source reference. Confirm exact model applicability in the original material.