3. RemoveATF pan (loosen screws crosswise). 11. UnscrewATFfiller screw(2). · 4. RemoveATF filter.

911 Carrera (996) Maintenance 3. RemoveATF pan (loosen screws crosswise). 11. UnscrewATFfiller screw(2). 4. RemoveATF filter. \ \ 2 '-~ .::.:.:.:--- 187-97 12. Suspendfilled ATF container (special tool 283-97 V.A.G. 1924) as high as possible on the ve- hicle and fill in ATF until it overflows. 5. Thinly coat gasket on the suction collar of the ATF filter with Vaselineand installfilter. Note The filler hook must be carefully inserted into 6. Tighten fastening screws for the ATF filter to one of the openings of the ATF guard cap (4) on 6 Nm (4.5 ftlb.). the filler hole. When doing so, do not move the filler hook upwards, since the oil guard cap (4) 7. CleanATFpan. can spring off upwards. 8. Clean all four magnets and place them in the 13. Move selector lever to position "P"and allow seams of the ATF pan (they must lie flat over engineto idle. their entire surface). 14. With enginerunning, top up ATF again until 9. Fit ATF pan with new seal. Tighten the screws excess ATF emerges from the bore of the crosswise in several stages. ATF filler screw (2). Tighteningtorque: 10 Nm (7.5 ftlb) 15. With the brake pedal pressed, change 10. Replace sealing ring for ATF drain plug and through all selector lever positions, re- tighten plug to 40 Nm (29 ftlb.). maining in each position for approx. 10 s. 16. Check ATF level. The following test condi- tions must be observed: 03 20 00 Maintenance 03 -21 Printed in Germany. 1997 996031