997 Carrera — Turbo Engine Lid & Wing Conversion / PAGE 12
Below are the clips along the top edge - as removed. Pull lightly from the bottom, with excess force the · clips will be bent (but
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
RennKit
Below are the clips along the top edge - as removed. Pull lightly from the bottom, with excess force the
clips will be bent (but they bent back easily).
There are two recesses that house the nuts holding the outer panel on. To remove, it is helpful to have a
second set of hands to hold the panel steady from the outside while you remove the nuts. Be sure to keep
the panel fully engaged against the car when removing each nut, to keep the bolt as far downward as
possible. This helps keep the bolt as close to the opening as possible so the nut is not dropped inside the
recess. It would be difficult to recover and i might rattle.
12
This is a source reference. Confirm exact model applicability in the original material.