Disassembling and assembling bearing housing with crankshaft · Danger to engine if connecting-rod bearing cap and connecting rod

Disassembling and assembling bearing housing with crankshaft Warning! Danger to engine if connecting-rod bearing cap and connecting rod are mixed up! & The connecting-rodbearing caps must alwaysremain allocated to the respective connecting rods and must never be interchanged. Recommendation: After disassembly, immediately reioin the connecting-rod bearing cap and connecting rod or mark them on the sides with an electric scribing tool (e,g. with the cylinder designation), Never mark these parts with sharp objects such as prick punches or number embossing tools. Note: No. Designation Removal Installation Connecting-rod bolt 6 Lightly oil thread and bearing surface 2 Connecting-rodbearing cap, cyl. 4 3 Connectingrod, cyl. 4 1 Immediatelyjoin with the connecting-rodbearing cap after removal 4 Connecting-rodbearing 1 cap. cyl. 5 5 Connectingrod, cyl. 5 1 Immediatelyjoin with the connecting-rodbearing cap after removal 6 Connecting-rodbearing 1 cap, cyl. 6 7 Connectingrod, cyl. 6 1 Immediatelyjoin with the connecting-rodbearing cap after removal 8 Connecting-rodbearing 6 Replace shell half 9 Thrust-bearingscrew 14 Lightly oil bearing M9 x 127 surface and thread 10 Bearing housing half, 1 cylinder bank 1 -3 11 Crankshaftbearing 7 Replace; shell half insert in correct position, locating stud faces towards dowel-sleeveside 13 -25 Qty.1