Engine -Crankshaft, pistons 911 Carrera (996) · No. Designation Qty. Removal

Engine -Crankshaft, pistons 911 Carrera (996) Note: No. Designation Qty. Removal Installation 12 Oil spray jets for piston 3 Press out from rear side of Press in with plastic cooling in bearing housing bearing housing half using mandrel (4 mm) half, cylinder bank 1 -3 a plastic mandrel 13 Cylindrical pin A4.0 x 10 1 Check for bending 14 Roll pin 6.0 x 16 1 15 Crankshaft 1 Check axial play. Never process bearing pins e.g. by sanding 16 Thrust plate 2 Replace, insert in correct position into bearing-housinghalf (cyl. 4 -6), oil groove faces the belt pulley, oil groove of opposite thrust plate faces the flywheel, insert thrust plates with grease 17 Crankshaftbearing 7 Insert in correct position, shell half locating stud or anti-turn lock towards dowel-sleeveside 18 Oil spray jets for piston 3 Press in with plastic cooling in bearing housing mandrel (4 mm) half, cylinder bank 4 -6 19 Dowel sleeve in bearing 3 Check that it is present housing half cylinder and seated properly bank 4 -6 20 Pin for tensioning rail 1 Press into bearing housing half (cyl. 4 -6) 21 Bearing housing half I 1 Do not damage sealing cylinder bank 4 -6 surfaces, fit on assembly fixture (special tool 9607) and fasten with MID x 30 hexagon-headbolts 13 -26 13 49 37 Disassembling and assembling bearing housing with crankshaft13