Pelican Parts

Ims help

Add to repair workspace

New repair projectOpen repair workspace

Original source

2 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis

THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHIms help

Leading reported evidence

Use kit

Suggestion or failed attempt

No successful repair reported for this finding.

0
Reported fixes: 0
Unsuccessful attempts: 1
Discussions

Read evidence and context

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that contain suggestions: 1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Suggestion · Original poster
Ok, so while installing the ne IMS bearing using the kit from LN engineering I didn't notice the installion tool did not fit over the new stud properly and ended up pushing it right out of the bearing and into the shaft.
Original post Read captured discussion
Ims help

Read full discussion summary

Leading evidence: 'Use kit' (no explicit attributable resolution; this is a reported action or suggestion). Across 1 matching discussions, The most frequently discussed action is 'Use kit' (1 discussions). For that action, 0 discussions report a resolution and 0 report an unsuccessful attempt. No action has an explicit, attributable resolution report under the current rules. These are forum reports and suggestions, not a confirmed diagnosis.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

1 matching discussions · 2 captured posts examined · 0 partial discussions

Frequently discussed actions (1)

These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.

Use kit

No successful repair reported for this finding.

0
Reported fixes: 0
Unsuccessful attempts: 1
Discussions

Read evidence and context

Discussions that contain suggestions: 1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Suggestion · Original poster
Ok, so while installing the ne IMS bearing using the kit from LN engineering I didn't notice the installion tool did not fit over the new stud properly and ended up pushing it right out of the bearing and into the shaft.
Original post Read captured discussion
Ims help

Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

2 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

Pelican Parts: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

0 acknowledgements have no verified action link; they do not establish a repair result.

Generation: 20261026T203514Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

Ok, so while installing the ne IMS bearing using the kit from LN engineering I didn't notice the installion tool did not fit over the new stud properly and ended up pushing it right out of the bearing and into the shaft. I was able to fish it out and reinsall it with the removal tool but ended up pulling the new bearing completely out. Can I still use this or did I just cost myself a grand?

POST 2Original post

The bearing, once extracted, should not be reused.

This is a source reference. Confirm exact model applicability in the original material.