Window problems fixed

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that contain suggestions

1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Suggestion

The solution I found was to change the door winder mechanism, actually a much easier job than changing the door latch - you just remove the door liner, unplug the 3 plugs from the winder (pull out the 2 red latches then squeeze the latch from below and they come out easy, on the 3rd the orange bar swings upwards), unscrew the 3 screws holding the winder in place, gently pull the winder off the spline.

Original post Read captured discussion

Window problems fixed

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that contain suggestions

1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Suggestion

Just make sure you use the screws to pull the new winder onto the spline, if you try to push it on the part you are pushing it onto in the door will fall down back and you will have to take more of the door apart to get it back again - not difficult just annoying.

Original post Read captured discussion

Window problems fixed

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that report an unsuccessful attempt

1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Unsuccessful attempt

That meant that every time someone used the door you had to go round to the drivers side and wind the window up on the switch with the added danger of forgetting, having the car flood in the rain and fry the computer under the passenger seat. There seem to be many forum posts with similar, but subtly different, issues that point to a micro switch in the door latch - I changed that but this problem persisted.

Original post Read captured discussion

Window problems fixed