fullymatted.
Back to search
Rennlist

DRLs not working

Add to repair workspace
Open repair workspace
Original source
13 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHDRLs not working

Reported repair

Repair within seconds

Reported resolution
1
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that report a fix
1

1 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Reported fix · Original poster

Fixed within seconds.

DRLs not working
Read full discussion summary

Leading evidence: 'Repair within seconds' (1 discussions report resolution; 0 report an unsuccessful attempt). Across 1 matching discussions, The most frequently discussed action is 'Repair within seconds' (1 discussions). For that action, 1 discussions report a resolution and 0 report an unsuccessful attempt. The most frequently reported fix is 'Repair within seconds', supported by resolution reports in 1 discussions. These are forum reports and suggestions, not a confirmed diagnosis.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

1 matching discussions · 13 captured posts examined · 0 partial discussions

Frequently discussed actions (1)

These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.

Repair within seconds

1
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context
Discussions that report a fix
1

1 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Reported fix · Original poster

Fixed within seconds.

DRLs not working
Actions with reported resolution accounts (1)

These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.

Repair within seconds

1
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context
Discussions that report a fix
1

1 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Reported fix · Original poster

Fixed within seconds.

DRLs not working
Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

13 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

  • Rennlist: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

1 acknowledgements have no verified action link; they do not establish a repair result.

Outcome without a verified action link

OK I solved it.

No unique explicit quoted action; no causal link assigned

Generation: 20261028T003752Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

Dammit.... I just fitted DRLs and made some kind of wrong connection as they are not lighting up as the ignition is switched on. I am sure it is something I have failed to do and should get it right before the day is out. Just taking a breather and venting my anger.

POST 2 / ORIGINAL POSTEROriginal post

OK I solved it. I had the two wires the wrong way around. Fixed within seconds.

POST 3Original post

Hey Hurdi. Those look good. Can I ask where you found those? Also, any chance of close ups? Thanks!

POST 4 / ORIGINAL POSTEROriginal post

Sure Whitlow.. This is my actual lights won on ebay. They were buy it now at $35 starting at $17-99c. Free delivary. Click on the picture. http://www.ebay.com/itm/361283472248?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT They are only a few ounces in weight and double sided tape sticks them easily and thoroughly. If I had my time to do again I would have stuck them to the underside of where they are now. Unfortunately they are now STUCK and I mean STUCK STUCK. I have my DLRS + GPS + Radar detector all coming on as I turn the ignition on. I picked up the electrical source for all three from behind the panel next to my driving foot. There is a double plug with 4 wires in there. One part is ON all the time. The other part becomes live as the ignition switch is turned on. The whole job to buy and install the DRLs cost me less then $20..

POST 5Original post

Those actually look fairly bright for eBay stuff in that photo. How does it look in bright day light from an offset view angle, like cars that would be approaching from the other side?

POST 6 / ORIGINAL POSTEROriginal post

Not very good in Bright sunshine. But good in cloudy day. Actually brighter or should I say 'whiter' light than any other on the car. It doesn't show in the photos though. Like I say if I had my time to do it again I would have stuck them under the lip as against standing on top of the lip. Plus if another driver or pedestrian have to rely on seeing DLRs and cannot see a 996 car on a bright sunlit day, then they should not be out on the roads. They look good and serve the purpose I think. BTW right now I see the same ones on ebay for less than I paid for mine. Some as low as $6 for the pair and free shipping. They are the exact same as mine. http://www.ebay.com/itm/2X-8LED-Whit...918d69&vxp=mtr http://www.ebay.com/itm/WHITE-DRL-2X...1c4455&vxp=mtr http://www.ebay.com/itm/2X-Super-Whi...b3595e&vxp=mtr

POST 7Original post

Quotes source post: 12275996

Lights look good, and sounds like they were pretty straightforward to install. I may pick a set up. Thanks for the eBay links. One more question. For your radiator intake grills, did you by any chance get those from Rennline? ( here ) Yours look good, and I've been thinking of doing the same thing to limit the amount of crap that makes it back to my radiators. If they are the Rennline ones, were they pretty easy to install? Thanks again. -Don

POST 8Original post

Quotes source post: 12274763

Full Chav, well done sir!

POST 9 / ORIGINAL POSTEROriginal post

Quotes source post: 12276248

I made them myself for $5... Just the same mesh as rennline honestly. Leaf Guards from a local hardware store. I wasn't for paying out $300 for the rennlist ones. They have been in all kinds of weather and never tarnish. One gutter guard made both sides for actually less than $5.. Here is a posting I made a while back about doing the DIY involved. I suspected my DRL thread would turn into a gutter guard thread when you all saw them close up. Best mod I ever thought of. https://rennlist.com/forums/996-foru...ir-scoops.html Read all the postings as one guy did the same with gutter guard to his 997. It's looks terrific.

POST 10Original post

Quotes source post: 12276306

Great DIY and nice post on how you did them. Thanks! I wish the Rennline ones were cheaper. I can't imagine they need to be priced that high even with development, manufacturing, and overhead costs factored in. If they would knock 1/2 off their asking price, I'd be inclined to get them, just to avoid having to fabricate something myself. As it is, it looks like I'll be shopping for some Gutter Guard in the near future. Thanks again.

POST 11Original post

Those eBay lights really contrast nicely against the chicken wire. Just messing with you, Hurdi. Nice job.

POST 12Original post

Anyone have any "Powered by Home Depot" stickers anywhere?

POST 13 / ORIGINAL POSTEROriginal post

Quotes source post: 12276668

I believe that Home Depo sell the gutter guards. These can be hand bent easily cut to shape with rose pruners.

This is a source reference. Confirm exact model applicability in the original material.