fullymatted.
Back to search
Rennlist

Vibration/buzzing coming from the dash

Add to repair workspace
Open repair workspace
Original source
16 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHVibration/buzzing coming from the dash

Reported or suspected cause

source of the buzz was the vibrator

Reported cause

No successful repair reported for this finding.

1
Identified cause
0
Suspected cause
0
Reported fixes
Read evidence and context

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that report identifying a cause
1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Reported cause

After all that work, it turned out that the source of the buzz was the vibrator that Chuck hid back there.

Vibration/buzzing coming from the dash
Read full discussion summary

Leading evidence: 'source of the buzz was the vibrator' (1 discussions report identifying this cause; no attributable repair resolution). Across 1 matching discussions, the most frequently mentioned possible cause is 'source of the buzz was the vibrator' (1 discussions; 1 report identifying it and 0 suggest it). No action has an explicit, attributable resolution report under the current rules. These are forum reports and suggestions, not a confirmed diagnosis.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

1 matching discussions · 16 captured posts examined · 0 partial discussions

Reported and suspected causes (1)

These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.

source of the buzz was the vibrator

No successful repair reported for this finding.

1
Identified cause
0
Suspected cause
0
Reported fixes
Read evidence and context
Discussions that report identifying a cause
1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Reported cause

After all that work, it turned out that the source of the buzz was the vibrator that Chuck hid back there.

Vibration/buzzing coming from the dash
Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

16 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

  • Rennlist: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

1 acknowledgements have no verified action link; they do not establish a repair result.

Outcome without a verified action link

Fixed it for me.

No unique explicit quoted action; no causal link assigned

Generation: 20261026T152433Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

I wonder if anyone else has experienced this, and more importantly corrected it. I have an annoying buzzing/vibration which seems to be coming from the central dashboard. It is not there when the car is cold (for example in the morning just out of the garage) but does emerge once the heat has warmed the car up to normal and/or it has been out in the sun for a while. It occurs between 3-4000 RPM and most loudest under harder acceleration. I don't think it is the cup hoder as I have played with that and it does not seem to stop it. I also don't think it is the middle console. Seems to be in the dash. Anyone have any thoughts or suggestions? Thanks.

POST 2Original post

I have an annoying rattle form the dash also but I pinpointed where the noise is coming from. One is from the lefthand side gauge console area. The other is the 'plastic cover thingy' at the center dash right next to the windshield. I haven't had the time to open it up and tighten everything down.

POST 3Original post

Quotes source post: 5293420

My aluminum guage rings were doing that. I had to re-install them with better sticky tape Fixed it for me. Good luck! -td

POST 4Original post

My alarm light does that in mine. Apparently, wedging some felt in there can do the trick. J

POST 5 / ORIGINAL POSTEROriginal post

Wedging where? Do you mean between the alarm light and the windshield? How do you get at it? By opening it up do you mean removing the dash? Is it difficult to do? I will do a search here and see if I can find instructions.

POST 6Original post

I have the same (or a similar) buzzing coming from the **passenger side** dash area that's DRIVING ME ABSOLUTELY NUTS I'm going to take apart the in-dash speaker cover this weekend and see if it's in there. Or possibly it's in the passenger-sdie airbag compartment? Rattles and buzzes make me insane, especially in a car of this caliber.

POST 7Original post

My buzzing was coming from the aluminum shift ring around my gear shift at the bottom near the boot. I can put my hand on it and it quits. Mike

POST 8Original post

not sure on where to place the felt....I haven't attempted it yet...with warmer weather approaching, I'm hoping I won't have to deal with it till fall again. But, I was thinking of placing or wedging a small piece in the gap b/w the light housing and dash...in the rear portion. When I hold that light housing down, the squeak goes away.. J

POST 9 / ORIGINAL POSTEROriginal post

This does sound similar to mine. It is more a buzzing/vibration than a squeak or rattle, and it does seem to be coming from the passenger side. How do you get the speaker cover off, or get into the airbag compartment? do you have to remove the dash? Please let me know how you make out. Thanks,

POST 10Original post

The speaker and cover come off with two torx style bolts. It is a five minute job to remove and you can reach down to the airbag area when the speaker is out. A small piece of 3M two sided tape gets rid of most rattles. Ask me how I know...

POST 11Original post

Mark, maybe it's just me, but I think that first pic shows steps that are a little drastic just to get rid of a few dashboard rattles!

POST 12Original post

Tim, I couldn't help it....those rattles drove me nuts. You should see how much 3M tape I used. After all that work, it turned out that the source of the buzz was the vibrator that Chuck hid back there.

POST 13Original post

Quotes source post: 5302378

:roflmao pics or ban!!!.... ah no wait I dont want to see that!

POST 14Original post

is it a quiet buzz? mine has developed this in the last maybe 6 months? it is quiet enought that i can drown it but it is annoying. it is rpm related and is from the upper part of the dash around the window. i thought it might be my dash surround as i put a leather one in a year or more ago. the sound may be cold ambient temperature related but i really have not been able to see the pattern of occurance.

POST 15Original post

Quotes source post: 5302378

LOL!!!! Hey, maybe THAT was the cause of the fire?

POST 16Original post

Mark: I was hoping that the batteries in that vibrator had run out...but they must have been Duracells......you didn't have to post that in a public forum you know...you could have been a little more discreet. Of course Tim didn't cut any slack either.

This is a source reference. Confirm exact model applicability in the original material.