10 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
THIS DISCUSSION / SOURCE-DERIVED OVERVIEW
Discussion summary
YOUR RESEARCHHead Gasket?
Leading reported evidence
Run from the heads
Suggestion or failed attempt
No successful repair reported for this finding.
0
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context
Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.
Discussions that contain suggestions
1
0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.
0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.
Suggestion
Stick your head up under your car and you will see 3 tubes running from the heads to the block - these let the oil drain back down to the sump so no need for a gasket there either.
Leading evidence: 'Run from the heads' (no explicit attributable resolution; this is a reported action or suggestion). Across 1 matching discussions, The most frequently discussed action is 'Run from the heads' (1 discussions). For that action, 0 discussions report a resolution and 0 report an unsuccessful attempt. No action has an explicit, attributable resolution report under the current rules. These are forum reports and suggestions, not a confirmed diagnosis.
Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.
These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.
Run from the heads
No successful repair reported for this finding.
0
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context
Discussions that contain suggestions
1
0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.
0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.
Suggestion
Stick your head up under your car and you will see 3 tubes running from the heads to the block - these let the oil drain back down to the sump so no need for a gasket there either.
Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.
10 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.
911uk: 1 discussions
0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.
0 acknowledgements have no verified action link; they do not establish a repair result.
Generation: 20261026T161109Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources
I have just topped up the oil on my 1986 3.2 - I had let it get a bit low - and I noticed some rather worrying yellow frothy stuff around the oil filler cap. I have a nasty feeling that this could be a sign that the head gasket is about to go - but I guess it could also just be caused by condensation around the oil filler. Any ideas?
Toby
Migration info. Legacy thread was 26166
3.2 Carrera is air cooled, doesn't have a head gasket !!
The emulsion is caused by condensation, worse in winter and if you do lots of short journeys.
Don't worry about it.
Migration info. Legacy thread was 26224
Thanks Matt - I feel a bit of an idiot now!! Can you explain further - isn't the gasket just the piece that goes between the cylinder head and the engine block. Sureley any car - air or water cooled has one of these - this is what I am worried has broken.
Toby
Migration info. Legacy thread was 26251
The white emulsion under the cap is very common on these cars. Take it for a nice long blast and get the oil temp up. This should get rid of any condensation and stop the oil tank resembling a mayonnaise factory.
These cars don't have head gaskets just a sealing ring. Think of the ring round the combustion chamber holes on a water-cooled head gasket
On a water cooled car the head bolts onto the block and the water passages in the head gasket allow the entire cylinder and combustion chamber to be surrounded by water.
The other holes in the gasket allow oil to drain back down from the head and into the sump.
Instead of being surrounded by a jacket of water, the 911's cylinders and heads are cooled by air being blown down onto and across it by the engine fan. The cylinders are finned like a motorbike engine to maximise surface area. Stick your head up under your car and you will see 3 tubes running from the heads to the block - these let the oil drain back down to the sump so no need for a gasket there either.
Technically speaking these cars don't have a block. It's a case. The cylinders attatch to the case, and the heads go onto the cylinders. Oh, and the case splits in two with the crankshaft sandwiched in between the two halfs.
Different huh?
Migration info. Legacy thread was 26292
As 911mot says, the 911 engine doesn't have an engine block just a crankcase and individual finned (for cooling) cylinders that fit into the cylinder heads.
Even if one of the cylinders was somehow leaking where it joined the cylinder head, this wouldn't cause white/yellow emulsion to form, because no water would be able to get into the oil. The cylinder would have low compression and hence the engine less power.
On a normal water cooled engine if the head gasket fails then water gets into the oil, forming the emulsion. The fact this can't happen is one of the big advantages of an air cooled engine, so stop worrying !!
Migration info. Legacy thread was 26311
Thanks for this chaps - I am now wised up! Various bikers in my office had tried to explain this to me - but not nearly as well as both of you.
Toby
Migration info. Legacy thread was 26315
spoke to OPC apparently as mentioned above it is common in cars making regular short trips in winter and oil not heating up, it will be dealt with at next service. This is a relief though quote for 24k service at £625 seems a bit steep.
Migration info. Legacy thread was 26904
That does seem a little steep.
I just had the 48month/48,000 miles service done, with brake fluid change and main belt for little more.
I would suggest you ring around a few OPC's - I've found some significant differencies in service pricing.
Good luck
Migration info. Legacy thread was 26913
This is a source reference. Confirm exact model applicability in the original material.
