fullymatted.
Back to search
Porsche Club GB

Cruise Control Retrofit

Add to repair workspace
Open repair workspace
Original source
15 captured repliesDiscussion pagination complete · Source accounts, not a confirmed diagnosis
THIS DISCUSSION / SOURCE-DERIVED OVERVIEW

Discussion summary

YOUR RESEARCHCruise Control Retrofit

Leading reported evidence

Install by my opc, and it cost over £800

Performed · outcome unconfirmed

No successful repair reported for this finding.

0
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context

Explicit resolution reports before identified causes, performed actions and suggestions. Within each level, matching component labels precede direct query mentions and inherited thread context; successful versus unsuccessful discussion counts, owner confirmations and independent discussion support determine order. This is not a probability of success.

Discussions that performed work without a confirmed outcome
1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Performed · outcome unconfirmed

Back in 1988 I had a 944 turbo, and I was doing quite a lot of motorway mileage, and had the OE Tempostat system retro-fitted by my OPC, and it cost over £800 then.

Cruise Control Retrofit
Read full discussion summary

Leading evidence: 'Install by my opc, and it cost over £800' (no explicit attributable resolution; this is a reported action or suggestion). Across 1 matching discussions, The most frequently discussed action is 'Install by my opc, and it cost over £800' (1 discussions). For that action, 0 discussions report a resolution and 0 report an unsuccessful attempt. No action has an explicit, attributable resolution report under the current rules. These are forum reports and suggestions, not a confirmed diagnosis.

Source reports, not a diagnosis or a success probability. Counts refer to discussions and can overlap.

Read captured replies

1 matching discussions · 15 captured posts examined · 0 partial discussions

Frequently discussed actions (1)

These are separate views of the same evidence. Frequency alone does not establish a fix, and these counts must not be added together.

Install by my opc, and it cost over £800

No successful repair reported for this finding.

0
Reported fixes
0
Unsuccessful attempts
1
Discussions
Read evidence and context
Discussions that performed work without a confirmed outcome
1

0 original-poster resolution reports. Counts can overlap; they are not unique people or a success rate.

0 discussions have direct query context; 0 report a fix in that context. Other evidence may inherit the discussion’s subject.

Performed · outcome unconfirmed

Back in 1988 I had a 944 turbo, and I was doing quite a lot of motorway mileage, and had the OE Tempostat system retro-fitted by my OPC, and it cost over £800 then.

Cruise Control Retrofit
Coverage and how to read this overview

Counts describe captured discussions, not unique people or a diagnosis. Author identities are not reliably stored. Exact duplicate evidence is counted once across matching discussions; one discussion counts at most once per action/state. Multiple repairs reported together remain a combination. Suggestions and failed attempts do not establish a fix. Matches cover whole discussions and can include related faults, model variants and incomplete threads.

15 eligible posts · 0 unverified posts · 1 discussions match the subject in their title or opening post.

  • Porsche Club GB: 1 discussions

0 evidence records excluded for query context · 0 excluded by outcome qualification · 0 adjusted by outcome qualification.

0 acknowledgements have no verified action link; they do not establish a repair result.

Generation: 20261027T064914Z · outcome-qualification-6. Deterministic extraction; no AI model inference. How we use sources

POST 1 / ORIGINAL POSTEROriginal post

Anyone know if it is possible to retrofit cruise control to a 996 turbo? Seen a car which is well specc'd apart from this which I find useful in keeping to the speed limit along a camera infested 40 limit for example.

POST 2Original post

For road use, cruise is a very useful option - once you become familiar with it. But it's not a 'speed limiter' as F1 drivers have in the pit lane, so not easy to use in typical 30 - 40 mph zones. Unfortunately, I don't think it can be economically retro-fitted on a 2003 996, unless the provision was left in the electrical system, which is now increasingly dependent on fibre optics. Back in 1988 I had a 944 turbo, and I was doing quite a lot of motorway mileage, and had the OE Tempostat system retro-fitted by my OPC, and it cost over £800 then.

POST 3Original post

I doubt cruise control would work well at such low speeds. Much better to reply on the speed limiter warning that's part of the BC. Or buy yourself a road angel or other GPS detector and have it chime when you're close to a camera. will be much cheaper than cruise control. Incidentally my local woolies now sells a GPS camera detector for £70!

POST 4 / ORIGINAL POSTEROriginal post

Actually, it works perfectly well, even down to 30 mph. I have it in my 996 C4S and find it useful flogging round the North Circular or those bits of SW London where there are so many cameras like the A30. It's only £200 - £300 as an option, so cannot be much. A control unit, an extra column stalk, some wiring, a switch on the brake and clutch pedals and the light on the speedo. I daresay there's more to it than that, but the salesman told me it was a no-no.

POST 5Original post

I agree, CC on my GT3 (yes) works perfectly, even down hill, so if you can, retrofit it.

POST 6Original post

http://www.renntech.org/forums/index.php?showtopic=661

POST 7Original post

Tool Pants is right. It is a (relatively) simple process to retrofit cruise (and the OBC) to 996's with fly-by-wire throttle. The Motronic DME has all the software already available, and it just needs connecting up, and activating with the PST2. If you approach an OPC they will probably tell you it isn't possible, but believe me - it is. I know an independent who can do it if you don't fancy tackling it yourself.

POST 8Original post

Here's to Toolpants ! Let's drink to him and all his ilk - splendid fellow that he is ! Were it not for his knowledge and skills, I'd have gotten rid of my 996 altogether ; as it is, all I have done is sweeten "'er Indoors" up by giving it to to her. At least it is still in the family ! Aplogies, gentlemen and readers, but I am merily pissed, for tomorrow I start a 3 week holiday in my Tuscan farmhouse--------propelled there by our 996 Cab ! SGLB

POST 9Original post

Richard, Which Independant would retro fit cruise? Martin

POST 10Original post

I was at the same independent as Richard as it was my car they were discussing (albeit a C4 not a Turbo). I'm sure if you ask nicely... [ ] Click Here Edited to add: I blew the extra cash on SmartTop instead....

POST 11 / ORIGINAL POSTEROriginal post

Sadly, the 996 turbo I had my eye on has been snapped from under my feet. Never mind, there's always another car out there. Thanks for your responses.

POST 12 / ORIGINAL POSTEROriginal post

And so there was (another car out there), picking it up today. [ ] Porsche GB were adamant it couldn't done, more like they couldn't be arsed. Contacted the service place next to the factory and they've come back saying no problem, just need your VIN no; they didn't say how much it cost though. Have heard this before, taking the car "back to base" makes the average OPC look a bit amateurish. Just the job if you are visiting the factory or heading south for the hols.

POST 13Original post

congratulations on the new motor..V-nice..[ ] garyw

POST 14Original post

A Chirf Inspecter from the MET I met skiing suggested the best cruise control on the market was 9 points on your licence. Bit of a wag, drove a Prius, say no more.

POST 15 / ORIGINAL POSTEROriginal post

Thank you, I'm very pleased, it certainly has a turn of speed!

This is a source reference. Confirm exact model applicability in the original material.