45 58 01 Checking transverse acceleration sensor · Notes on the test

45 58 01 Checking transverse acceleration sensor Notes on the test The purpose of the test is to ensure the following points: correct installation position of the sensor functioning of the sensor Connect Porsche System Tester 2. The diagnostic socket (arrow/Figure 625_96) to which the Porsche System Tester 2 is connected is located in the driver's footwell (left-handdrive vehicles)or passenger's 2. Select the "Actual values" menu/ footwell (right-handdrive vehicles)near the "Transverse accel. sensor" sub-menu fuse box. with the Porsche System Tester 2 in the PSM system. Entry to the PSM system takes place through the ABS system (automatic status change after PSM). 3. Check and note or store the value of the transverse acceleration sensor in the normal position of the vehicle. Nominal value: 0.0 m/s2:t 0.4 mjs2. Note Normal position means: Vehicle on level surface. If the vehicle was raised beforehand,relieve 547_96 the wheel suspensionsif necessary (move the vehicle a few meters as well as rocking it up and down at the front and rear a few times). If a value other than the nominalvalue is displayed,an open circuit is present in the lead route or the transverse acceleration sensor is faulty. 45 58 01 Checking transverse acceleration sensor 45-119 Printed in Germany -28, 1999 C4_451 09