30 30 19 Removing and installing clutch slave cylinder · 1. Unscrewthe front rear-axle cross member

911 Carrera (996) Clutch, actuation 30 30 19 Removing and installing clutch slave cylinder Removal 1. Unscrewthe front rear-axle cross member (two MID screws) to facilitate subsequent / assemblywork. 2. Detach line No.1 on the clutch slave cylinder and remove line from holder No.2. Cover or close line No.1 and the connection bore in the clutch slave cylinder. 3. Removeholder with clip No.2 (to facilitate assembly). To do this, undo the 2 screws 314_98 on the transmission side cover. Installation 4. Undo fastening screws No.3 and remove 1. Greaseend of the push rod of the clutch slave the clutch slave cylinderfrom the transmission cylinder -in the area located in the ball housing. socket of the release lever when installed - with a thin coat of Olista Longtime 3 EP Note (availableas a spare part). The following tools can be used to undo and tighten screws No.3: 2. Fit the clutch slave cylinder and tighten the fastening screws (23 Nm (17 ftlb.)). Lower screw: 3/8 inch changeover ratchet in combination with a short extension Note (approx. 100 mm long) and 13 mm socket When inserting clutch slave cylinderI it is wrench insert. necessaryto overcome the spring force acting on the push rod whilst fitting a fastening screw. Upper screw: 3/8 inch changeover ratchet Refer to the assembly instructionsin the in combination with an extension following text. (approx. 250 mm long), universaljoint and 13 mm socket wrench insert. 3030 19 Removing and installing clutch slave cylinder 30 -7 Printed in Germany -13, 1998 996307