996 Carrera Group 6 Body Equipment, Exterior / PAGE 29
Additional instructions for fitting the inner panels · Whenthe inner panels are being removed
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
911 Carrera (996) Sliding roof
Additional instructions for fitting the inner panels
Whenthe inner panels are being removed ~ or replaced, the sliding roof panel and -"',
sliding/tilting roof trim should be removed
and the gate of the roof frame should ~
be extended (tilting position).
'"'""--= ~
Removing inner panels
/ , ~I ,.,
-"''" /' ~~ '"/' /' 395_98 ~
~ Disengageleft and right inner side panels.
... Pull out the connector springs B on the gate
and pull the sliding/tilting roof trim upwards.
/'"
'"
./
394_98
Position the sliding/tilting roof trim dimensionA
approx. 80 mm in front of the roof edge cut-out.
396_98
Push the sides of the inner panels out
of the sliding roof frame inwards (centre
of the vehicle).
60 40 19 Removing and installing sliding roof panel 60-7
Printed in Germany -17, 1998 996601
~~I:\'.."
This is a source reference. Confirm exact model applicability in the original material.