No. Procedure Instructions · 15 Attach the mixing tube Slide the mixing tube (H3) in

No. Procedure Instructions 15 Attach the mixing tube Slide the mixing tube (H3) into the groove over the completed cartridge and fasten with the unionnut. 16 Insert the cartridge Insert the completed cartridge, including mixing tube, in the bonding gun into the bonding gun (F), Note Observeopentime of 15 minutes! The open time is the time within which the adhesive must be applied and the rear window inserted in the hardtopbody. 17 Fit the cover profile Push the cover profile onto the rear window. 18 Applyadhesiveon the hardtop Use the bondinggun to apply a triangular bead body in the area of of 2-componentadhesiveon the window aperture the window aperture of the hardtop body along the riveted joint. Dimension "X" = approx. 12 mm Take care when applyingthe adhesiveto ensure that the adhesivebead overlaps. Note Two persons are needed to install and adjust the rear window. 19 Insert the rear window in Insert the rear window at the top of the window aperture the body and carefully lay it down. 20 Fix the rear window Pushthe rear windowall of the way up and press the lower window edge into place. Secure the rear window against sliding out of place with adhesivetape at the sides and top. 64 86 19 Removing and installing rear window (hardtop) 64 -29 Printed in Germany -13, 1998 9966423