94 58 19 Removing and installing ignition unit for gas discharge lamp · Warning signs (yellow triangle

911 Carrera (996) Lights, lamps, switches exterior 94 58 19 Removing and installing ignition unit for gas discharge lamp Warning Warning signs (yellow triangle with black high-voltage arrow) ~ & indicate high voltage (risk of fatal injury). 0 / > The light must always be switched off when removing and installing ~ ! / / -~ / these components (control module, ignition unit, gas discharge lamp, servo motor), Once removed, a headlightis not under high voltage. 354_98 > The gas dischargelamp (025 lamp) may only be operated when installed in the reflector and with the headlightinstalled. Installation 1. Engagethe electrical plug connectionand Removal fasten the ignition unit to the headlight 1. Switchoff the light. housing.The high-voltagewire from the Releasethe headlighthousingand pull out control module must be routed between forwardsslightly. the headlighthousing and the ignition unit. 2. Disconnectthe electrical plug connection of 2. Lock the cover with control module and insert the automatic headlightbeam adjustment the headlighthousing in the wing. and remove the headlighthousing. 3. Engagethe electrical plug connection of 3. Releaseand open the cover with control the automatic headlightbeam adjustment module. Unscrewthe electricalplug connection and lock the headlighthousing in the wing. on the gas discharge lamp (bayonetlock). 4. Carryoutfunctioncheckof the headlights. 4. Undo the two fastening screws on the ignition unit and remove the ignition unit. Pull oft electrical plug connection. 9458 19 Removing and installing ignition unit for gas discharge lamp 94 -39 Printed in Germany -18, 1998 9969435 ~:~--